Pelletizer

Nylon, PC and other engineering plastics granulator
Models HX100 400-600KG / hr
HX 200 600-1200KG / hr
Other models
Motors, Siemens 5.5-15kw optional
Inverter, Siemens, Mitsubishi and other optional
Hob, imported from Germany or Taiwan imported tungsten steel optional

Rated voltage 380V
The maximum yield 600-800KG / H
Rated current 15.5A
Diced number of <= 23
Total power 7.5KW ~ 11KW
Cutter size φ200 × 150
Power Factor 0.8
Traction speed 5-60m / min
Pressure 0.6MP
Consumption 100cm3 / min

Fault and handling:
1 machine can not start
Press the button if KA1 relay action, such action then the fault lies in its contacts to the drive line, so the line is no problem you may
Is the drive parameters are changed, recalibrate its parameters. If no action is to check the doors are closed, the doors close to the switch tail lights
Are there lights. Whether the emergency stop switch is pressed and so on.
2 doors can not be opened
Make sure that the machine has completely stopped, and the running lights are off. Press the button if you can hear the sound of the solenoid valve is switched
Sound, it may be stuck or lock cylinder pressure is too low. If there is no sound, check the gas supply, inverter-related contact, this button and electromagnetic
Valve is faulty.

Care and maintenance:
Machine work more than 200h, the need for reinforcement of its various parts screws, parts of refueling activities. Check that both ends of the bearing wear
Damage, wear it as an emergency replacement. Also note that the machine is working at low speed motor heat. To prevent the motor from overheating.